小弟第二次整模型車,
我決定做返次製作過程.
Open Box開盒
睇睇有冇問題,假組
剪下內部零件
個 "令" 原先有電鍍, 不過小弟用漂白水洗掉啦
可見頭尾頭仲有電鍍
指住的是水口,遲下會 cut 走佢
可有見到收縮嗎,相信係製制成型時產生
我用過砂紙 sand, 比上一張較易見到收縮
以下我用 Tamiya 畢地, 小心唔好一次過落係同一個位,內有天拿水成份,用太多會傷及模型表面
Tamiya 有白色,用法一樣---"茶"
一定要等畢地完全,小弟通常會等一至兩日....如果唔係由頭黎過....
我想快dd, 所以用 160號
有師兄會用 400 至 1000, 時間會拉長左
Now the surface is being sand down to even level. YAY~!!!!
drill 前冇影,不過唔怕啦....
個位係定風尾翼, 以下係----"如何令 定風尾翼 定下來"
DA DA, Tamiya 2mm plastic beams
This is the final look of the "wing"
Firstly, I sprayed a layer of primer (1200 grid), and sanded with 2000 grid sandpaper together with water.
Then a layer of Tamiya Acrylic paint, X-2 Black.
if anyone have noticed the front of the car, the white area are the area I sanded down ONCE AGAIN. Because there were dust on it.
This is what happened after I have sanded.
(I first used 1500 grid, then 1200 grid, then 800 grid; lastly 1500 grid again)
Now, I re-spray a layer of black paint.
This time I did not use Tamiya Acrylic paint X-2, black.
I used Mr.Color 157 Super black.
I tried a close up shot, we can see the dust all over the car..=.=
repeat the process again......until it's smooth (NO dust)
a shot with the rim, I skipped a few shots.....
anyway, first I spray with Mr.Color 157 Super Black (skipped the shot)
then I sprayed 2 layers of Super Silver
last, I sprayed a layer of Smoke (Clear Black) (skipped the shot)
back to the body, this time I sprayed a layer of a mixed paint
50% Mr.Color 9 Gold + 50% Mr.Color Clear Yellow
the interior is completed
The model can fit in 4 "Frogs" ?!
Lastly, 4-5 layers of Tamiya Acrylic Clear Red.
Then 7-8 layers of Mr.Color GX-100 Super Clear.
sanded with 1200-2000 grid sandpapers
polished with Tamiya Compound (Coarse, Fine, Finish)
Finished~ I have made the details on the body
the vents, painted in Flat Black (Tamiya Acrylic X-2 black + Tamiya Acrylic Flat base)
Lastly, put it into my show room
分享
