原帖由
chlalan 於 2010-12-1 09:06 PM 發表
都好靚
1)你試吓用decal setter 睇吓soft唔soft到,如果唔得,用細針吉穿d泡,然後用decal setter 掃吓,唔一定得
2)光油唔夠,可以薄噴多一至兩層。
原帖由
Devil 於 2010-12-1 09:33 PM 發表
水貼問題最好噴光油前解決左佢先
噴左光油後難攪好多,軟化劑畀光油隔住,單靠拮穿或ɚ穿D位滲入去,效果差好遠
睇相光油好薄,好易一落砂紙就穿
原帖由
Raptors 於 2010-12-2 07:54 AM 發表
Before applying decal, the surface should be level. Since TS51 is a metallic paint, you should apply a few layers of clear coat first. Then wet sand the clear coat prior to apply decal. In your c ...
First of all, thnak you for your comments, and my english is quite poor, please forgive my grammar mistakes. I have already polished the metallic paint before applying the decals, but i think the intensity is not enough. Refer to your comments, "use knife to cut the decal between the door and make sure the decals are resting completely on the valley areas" should i also cut the corner (i mean the L part in the last photo ) to ensure there are no bubbles? altough i have applied the clear coat slowly and thin for the first three layers, next time i think i should flood it after a few more layer is added. By the way, i don't understand what is double action airbrush, i am now using spray can and i think it is quite difficult to porduece air without paint and i will try the method of using hair dryer if the decal softener do not work