thx for sharing the ¸Éªo method~ im sure it will be a life saver someday

­ì¨Ó«Y§Ú»~·|, ¦ý¤j¤jªº§@«~³o»ò±j¤~¥O§Ú¦³¦¹»~·|

Thanks
¦ý§Úd³¥ --- [Ú»¬Û¸Ø°Õ°Õ, ¹êª«¤p³â¥z]

­nÚ»¹êª«
Ëݯu¤Hshow ¨£°Õ

Front Wing Set


Tail Light On


Will set up the rear wing soon. Very Slow ar

Updated on 21/12/2006

All wings have been set. I did not expect the REAR WING was so difficult to set





I hope I could finsih it up by the end of 2006

ÂI¸Ñ·|¦³³¡ËݲÓge¯u¨®ga~~~~

Actually, this is a pissed poor work. Many many defect.

Updated on 21/12/2006

Starting working on cockpit detail. Close to final stage now.

¢ÒÁl«YAluminium,セ³¥¦â会¤W¡H¡H

No need to apply any color. I have seen a real front wing of 312T2 before. Its appearance looks the same as the current status.

However, if you really need to put some color on the PE. I'd suggest you may want to SAND the PE a little bit in order to make primer staying on the PE

Filters On

­Ó­·¹j d ¯¾¤Ó²Ê¦P­ø°÷±K......

You're right but no such detail part

Some more tonite

coming along really nicely DMAN~
really nice pregress

¦ý¢Ò¡@¢à¢ñ¢þ¢í¢ü¡@¦ì¬O¤£¬O¥Y¤£¬O¥Wªº¡H¡H¡H

¨ä¹ê©O¬[¨®«Y«§¤ñ¨Ò??

This is a 1/24

Actually, you are right on the Rivet Shape. I wanted to do such alternation by putting individual rivet at the inistal stage. However, I found this might be not feasible since the EDGE of the cockpit is very THIN and it is very hard/impossible to plant rivet there