can u guys tell me where is it... I want to buy a few more if its that cheap...

返大陸買真係可以以量取勝,記得好似係兩蚊十支一包(0.3~1.0)

嘩你整到好大工程
我想加長個身都唔識
真係高手!!!!!!

我見工個陣行過一間五金鋪,好齊貨

得閒睇下

大概依個位

can u help me to buy few packs... I would like to get a few sets...

well u can simple buy a book called "NOMO KEN"

then u know how to do all the basic work...

thx I will check it out when I have time...  many thx

哇~分件分得好細啊~~~好好技術!!!

Life~~!!
Get going... Stop replying People's Messages~~!! j/k

Hope to see your final work done. It seems alot of work.  But, you'll get the compliments later on.

Btw, where did you got that Nomoken book?  Is it possible you can take a few pictures of the inside pages? (Or inner page) Very curious about the techniques that're showing in that book.

Don't know if I should start a new project (For spraying) or try to concentrate in working..

(Another question, I need drills~!!! Can any brother recomment a set where I should get?? Mainly inexpensive and also the sizes of the drills I'll need.. Thx)

[ 本帖最後由 Solaraboy 於 2008-8-19 10:16 AM 編輯 ]

我想問鑽到咁有咩用呀.....

I am still a learner on cutting parts apart... sometime when I cutting them, I keep thinking will I have chance to putting them back to where it should be???

well I am just too tried from work past two nite... so didn't build any model at all...
I guess I will do some update tonite...

and yes I will take a few page inside of that book and post it here...

and for the drill... the cheap one u can simple goto Sham Shai Po to buy it... but I will say get the Tamiya one is better...
only money matter...

[ 本帖最後由 LifeAfterDeath 於 2008-8-19 06:27 PM 編輯 ]

well normally I can use up to 0.5mm easy... and 0.3mm is only for detail parts like my 1/300 SOG Gundam...

just an small update cux past few days was too tried... nothing much can do as all...

here are the few pages inside the book....

last 2 photos...

打磨地獄始動

almost there...

Where did you got the book then? *Curious*