原帖由 Quietfart 於 2006-10-19 10:32 AM 發表
Brother Louisuni,

Looking forward to your build!


QF

原帖由 Joe_Lo 於 2006-10-19 10:53 AM 發表

睇黎你都係 PE 狂迷, 我就真係無咁多精神加咁多 PE.

喂! 星期日 AFV 旺角 鴨仔團報左名未呀!

http://www.hkml.net/Discuz/viewt ... page%3D1&page=5

原帖由 R32 於 2006-10-19 10:58 AM 發表
louisuni 兄又咁快手又開工………，我果堆AFV山重越整越高當中…………………！！

原帖由 Quietfart 於 2006-10-19 11:01 AM 發表


Brother L,

I will try to look for you.

You like PE too huh?  I have the same problem haha...  However, 2 monthes ago I decide to build the old Tamiya Horch without the PE..it was so uncomfortable!!  But I managed to finish it... I think haha.

QF

原帖由 jammy_2002i 於 2006-10-19 11:18 AM 發表


tristar唔一件過出底盤會唔會因為模具成本問題? 底盤一件過而又要保留原來detail可能需要四面行位, 因此而成本高左?

原帖由 LinusPoon 於 2006-10-19 12:46 PM 發表

E 架4號仔砌出尼一定好靚

原帖由 joeyko2000 於 2006-10-19 01:20 PM 發表


咁我個架一定係唔砌係個盒入面靚D...
(即係唔好SIGN野...)

原帖由 ice 於 2006-10-19 01:34 PM 發表
真快手,期待有嘢睇

原帖由 buzz 於 2006-10-21 11:10 PM 發表

Ｄ PE 件好正
俾你毒咗, 明天又要洗錢

原帖由 Quietfart 於 2006-10-21 11:12 PM 發表
great job so far brother Louisuni

I know... the newer models are so complicated and so many parts!!  I built a AFV Club 88 and I had a terrible time building because it is so un-necessary complex.  I decide to stop building on step 42 because it was no longer fun.  One of my friends who build the same AFV kit threw his model at the wall on step 2!   He was so frustrated he counld not continue.

QF

原帖由 Joe_Lo 於 2006-10-23 07:01 PM 發表
呢 d 意外經常都會發生, 試下呢個方法 :

先用幼鑽咀在崩左一粒釘既地方鑽穿, 然後用廢膠料拉幼線方法或用幼膠條穿入並用膠水痴好. 乾後將穿入膠條 cut 剩小小 (大約 0.5 mm), 用幼蚊香將突出膠條溶少少做成窩釘形狀, 完成.

試下啦