偷膠?

我己經想像唔到成品會係幾正....
對我呢個small potato黎講....

估中.... 真係好鬼好心機... 可以"大概"稔到完成後係點... 一般我稔大部份人用scribber刻就算不過你呢隻方法會工整好多!

小弟唔係好明你指邊個位..
可否請兩位師兄講解下?
想學下野...謝謝

師兄?! 我無咩改造經驗架wor... heh我都係靠估... 見到中間夾左層係有三條分開嘛? 當佢磨稜邊磨到一定深度時果度就會o係'裙腳"顯露出兩個凹糟... 而中間細塊D果層我諗係磨既時候用黎guide住條邊唔好磨得過深?! 呢度我都唔係好明, 唔知佢係咪磨晒甘多條邊同會磨得有幾深, 都係等睇樓主post圖

[ 本帖最後由 eddie_ch 於 2008-6-9 09:16 PM 編輯 ]

Yes, it is more or less the same as your mentinoed.
But 中間細塊D果層just create a gap at side view.
Will post new picture soon.

oic!! cool! can't wait

But this step must be do it very careful.

係呀.. 個斜度有少少唔同, D凹糟大細就會幾明顯下... 可能要用電子卡呎度住甘續D續D磨   anyway 小心D! 加油!

唔該晒師兄~:
有少少明但又唔明得晒, 都係等樓主更新
熱切期待

我都用緊膠版搭大量大型野
大大的教學
真讓我獲益良多

Don't worry, my eyes are better than 電子卡呎 (faster to find out the different between two parts). Close to complete the right side. Will update soon.

You are welcome

超级劲 期待大作 快D UPDATA

heh was just kidding, but that's kinda the dum thing i'm used to do, my fd Eday keeps telling me i can just simply compare the pieces instead of always measuring it up and waste the time but i can't quite trust myself on making sure that the left and right are balanced, kinda why i can never really get anything done :P apart from admiring what everyone else can do heh...

無問題, 今晚可以磨好一邊裙甲
但仲要加番個 BALL JOIN, 否則裝唔番上個身体到. 個BALL JOIN 仲要小心地由原本塊裙甲到剪下來, 又不能 '飛' 太多膠料, 如果唔係唔夠位. 又要加銅位, 如果唔係唔夠力.

祝你既截跂手術成功~

cool! the angle is not as "slant" as i thought but still it's really neat!

I will make it more "slant" at the bottom edge, but the side edge will be keep the same.