Hi, this is the first model I have been assebling since 2004.
I am very disappointed by my skills Seems that I need time to pick up my skills.
Since I do not have a lor of material, I will only use sheet styrene to create new parts of details.
As you can see in the pic, I increased the width of the chest to demonstrate a powerful image
For the 4th pic, I combined two parts together and marked the intersection of their diagonal lines. Later use a hole puncher to make a hole which penertrates the intersection

[ 本帖最後由 sheakinsing 於 2007-2-1 03:36 AM 編輯 ]

A hole puncher and the board
Ater that, I did not thorw away the small round remaining part. I used it to cover the gap of the knee
Never waste natural resources

[ 本帖最後由 sheakinsing 於 2007-2-1 03:32 AM 編輯 ]

other parts. Just ignore the black lines

[ 本帖最後由 sheakinsing 於 2007-2-1 03:39 AM 編輯 ]

don't put that round piece at that gap, stick it on the arm

Good idea
Thks a lot.

wa~好正wor~
幾錢ga?? 直徑有無得換ga??
邊到有得買?

幾錢ga?? CA $2
直徑有無得換ga?? no
邊到有得買? Stationary stores

where did u got the styrene, if u got it in CA....where

P mall <<MY TOYS>>

i know that store, the store that have the gundam heads on display


how much did u got it for?
how many are in one pack?

I cannot remember, I believe it was less than CA$5. There are 3 pieces in 1 package. I had to buy 1 package. I think it is better and easier to cut than TAMIYA ones.

Cuz MY TOYS is one of the oversea agents of NEW G.

can u tell me the length of one piece? (??cm x ?? cm)

There size are standardized.
But I chose a package of boards which is 0.4mm thick

ok, gd enough, thx

不俗
　　　　

改得幾型WOR@@!
其待作品